Any suggestions on how to make the joint when you butt drywall to a timber frame post.
Yes, when making a butt joint to an exposed timber or to a window jamb, use a plastic J molding for drywall. The J molding is cut to length and slipped over the raw edge of the drywall. When installed it leaves a nice finished reveal which can be painted with the drywall. Wide side goes to the back.
Dave(Ask Dave) (About Dave)
As an introduction get free access to this article
and two others of your choice, just by entering
your email address below.
Receive our FREE Monthly newsletter which contains a
free set of woodworking plans each and every month.